FlowSim Pro – Flow Control Diagnostic System

Stop guessing. Start diagnosing.

This system allows full testing of flow control systems without running water or starting the aircraft. Designed for ag aviation systems including Satloc, Ag Pilot X, Ag Nav, DynaNav, Tabula, and more.

⚠️ The Problem With Traditional Testing

Most troubleshooting today relies on the “screwdriver test” — spinning a turbine sensor manually and hoping the system reacts.

No consistent signal
No control over flow rate
No way to simulate real operating conditions
Cannot test full system response

It’s not accurate. It’s not repeatable. And it doesn’t tell you what’s actually wrong.

🔧 Full System Testing — From Install to Troubleshooting

FlowSim Pro isn’t just for diagnosing problems — it’s a critical tool for installers and technicians from day one.

Verify the entire system is working correctly before it ever leaves the shop, and diagnose issues later with the same tool.

Confirm proper wiring and connections during install
Simulate flow and verify GPS/controller response
Adjust flow rate and watch real-time valve movement
Ensure correct rate control behavior before first use

Instead of finding problems in the field, you can catch them during install — saving time, avoiding callbacks, and preventing costly downtime.

🎯 Change Flow Rate — See Real Response

This isn’t a simple signal tester — you can actively control the flow rate going into the system.

Increase or decrease simulated flow
Watch the valve open and close accordingly
Verify proper rate control behavior

If the system is working correctly, it will react exactly like it does in the field:

Reduce flow → valve closes down
Increase flow → valve opens up
Shut off section → flow drops and valve responds

🚜 Simulate Real Field Conditions

You can test how the system reacts to real operating changes:

Change simulated speed
Adjust swath width
Verify correct flow rate per acre response

This ensures your system is calibrated and behaving correctly before you ever leave the ground.

🔍 Troubleshoot Problems Fast

Identify stuck or failing flow meters
Detect bad cables or wiring issues
Verify valve motor response
Isolate controller (CPU) problems

Test the system under controlled conditions instead of guessing or swapping parts.

⏱️ Save Hours of Time

No running water systems
No starting aircraft
No long troubleshooting sessions
No back-and-forth phone calls

What used to take hours now takes minutes.

🌎 Built for More Than Aviation

This system isn’t limited to ag aircraft.

Oil & gas applications
Farming equipment
Any system using 2-pin or 3-pin flow sensors

If it uses a flow signal, this tool can test it.

💰 Why Every Fleet Should Have One

Eliminates hours of troubleshooting time
Reduces unnecessary part replacement
Keeps equipment working instead of sitting
Pays for itself quickly in saved labor

If you run multiple machines or aircraft, this is not optional — it’s a necessity.

📦 Available Products

View FlowSim Pro Products →

Country/region

FlowSim Pro

FlowSim Pro – Flow Control Diagnostic System

FlowSim Pro | Ag Pilot X Conversion Cable-9017

Our newsletter

⚡ NEW 802 Exhaust Covers